Brocade Communications Systems Converged Enhanced Ethernet 53-1002163-02 - Manual (Page 49)

Converged Enhanced Ethernet Administrator’s Guide 27
53-1002163-02
Configuring the FCoE login information
4
DRAFT: BROCADE CONFIDENTIAL
Managing the current configuration transaction
NOTE
The configuration changes created using the fcoelogingroup command are kept in a transaction
buffer until you save the buffer using the fabric-wide fcoelogincfg--save command. The login
configuration is saved as a transaction, and to apply it you need to specifically save it.
Perform one of the following tasks to either display or abort the current configuration transaction.
Cleaning up login groups and VN_port mappings
Perform the following tasks to clean up login groups and VN_port mappings.
Displaying the FCoE login configuration
Perform the following tasks to display the FCoE login configuration.
Task Command
Display the current configuration transaction. switch:admin> fcoelogincfg --transshow
Abort the current configuration transaction. switch:admin> fcoelogincfg --transabort
Task Command
Perform a cleanup of all conflicting login groups
and VN_port mappings from the effective
configuration. This purges not only the conflicting
login groups but also the non-existing switches. switch:admin> fcoelogincfg --purge -conflicting
-nonexisting
Perform a cleanup of all conflicting login groups
and conflicting VN_port mappings from the
effective configuration. switch:admin> fcoelogincfg --purge -conflicting
Perform a cleanup of all login groups for
non-existing switches from the effective
configuration. switch:admin> fcoelogincfg --purge -nonexisting
Task Command
Display the FCoE login configuration. Syntax is as
follows:
•
-switch swwn—Displays all of the login
groups for the specified switch.
•
-logingroup lgname—Displays the login group
configuration for the specified login group.
•
-saved—Displays only the effective
configuration.
switch:admin> fcoelogincfg --show [-switch swwn |
-logingroup lgname] [-saved]
Display the status of the last configuration merge
during the last fabric merge. This operand also
displays conflicting login groups and login groups
for non-existing switches. switch:admin> fcoelogincfg --show [-mergestatus]