Brocade Communications Systems Converged Enhanced Ethernet 53-1002163-02 - Manual (Page 38)

16 Converged Enhanced Ethernet Administrator’s Guide
53-1002163-02
CEE Command Line Interface
2
DRAFT: BROCADE CONFIDENTIAL
NOTE
At system startup, if you try to enter privileged EXEC mode before the system has fully booted, the
following message is displayed:
%Info: Please wait. System configuration is being loaded.
After the system has fully booted, a RASlog message indicates that the CEE CLI is ready to accept
configuration commands.
TABLE 4 CEE CLI command modes
Command
mode Prompt How to access the command mode Description
EXEC switch> Enter the cmsh command at the
Fabric OS prompt after you have
logged in as an appropriate user. Display running system information
and set terminal line parameters.
Privileged
EXEC switch# From the EXEC mode, enter the
enable command. Display and change system
parameters. Note that this is the
administrative mode and also
includes EXEC mode commands.
Global
configuration switch(config)# From the EXEC mode, enter the
configure terminal EXEC command. Configure features that affect the
entire switch.
Interface
configuration Port-channel:
switch(conf-if-po-63)#
10-Gigabit Ethernet (CEE port):
switch(conf-if-te-0/1)#
VLAN:
switch(conf-if-vl-1)#
From the global configuration mode,
specify an interface by entering one
of the following commands:
•
interface port-channel
•
interface tengigabitethernet
•
interface vlan
Access and configure individual
interfaces.
Protocol
configuration LLDP:
switch(conf-lldp)#
Spanning-tree:
switch(conf-mstp)#
switch(conf-rstp)#
switch(conf-stp)#
From the global configuration mode,
specify a protocol by entering one of
the following commands:
•
protocol lldp
•
protocol spanning-tree mstp
•
protocol spanning-tree rstp
•
protocol spanning-tree stp
Access and configure protocols.