Brocade Communications Systems Converged Enhanced Ethernet 53-1002163-02 - Manual (Page 17)

Converged Enhanced Ethernet Administrator’s Guide xvii
53-1002163-02
DRAFT: BROCADE CONFIDENTIAL
About This Document
In this chapter
• How this document is organized . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xvii
• Supported hardware and software. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xviii
• What’s new in this document . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xviii
• Document conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xix
• Notice to the reader . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xx
• Additional information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xx
• Getting technical help . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xxi
• Document feedback . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xxii
How this document is organized
This document is organized to help you find the information that you want as quickly and easily as
possible.
The document contains the following components:
• Chapter 1, “Introducing FCoE,” provides an overview of Fibre Channel over Ethernet (FCoE) on
the Brocade FCoE hardware.
• Chapter 2, “Using the CEE CLI,” describes the Converged Enhanced Ethernet (CEE) CLI.
• Chapter 3, “Configuration management,” describes how to perform the administrative tasks
required by the Brocade FCoE hardware.
• Chapter 4, “FCoE Configuration Management,” describes how to configure FCoE using the
Fabric OS CLI.
• Chapter 5, “Initial FCoE and CEE Configuration,” describes some basic switch configurations
for command SAN and LAN environments.
• Chapter 6, “Configuring VLANs,” describes how to configure VLANs.
• Chapter 7, “Configuring STP, RSTP, and MSTP,” describes how to configure the Spanning Tree
Protocol (STP), Rapid STP (RSTP), and Multiple STP (MSTP).
• Chapter 8, “Configuring Link Aggregation,” describes how to configure Link Aggregation and
Link Aggregation Control Protocol (LACP).
• Chapter 9, “Configuring LLDP,” describes how to configure the Link Layer Discovery Protocol
(LLDP) and the Data Center Bridging (DCB) Capability Exchange Protocol (DCBX).
• Chapter 10, “Configuring ACLs,” describes how to configure Access Control Lists (ACLs).
• Chapter 11, “Configuring QoS,” describes how to configure Quality of Service (QoS).