Black Box ACU2222A - Manual (Page 37)

SERVSWITCH BRAND CATX KVM EXTENDER FAMILY
36
4.5 Other Remote Configuration &
Operation Options
Reset Commands
The ServSwitch Brand CATx KVM Extender Series has a number of commands to reset the
keyboard and mouse, to reset EQ and Delay values and to restore the factory default
configuration.
Command Key Sequence
Reset Mouse and Keyboard
Resets the keyboard and mouse and then automatically exits Command Mode. Use if the
mouse or keyboard locks up or the mouse does not initialize correctly.
Send NULL Mouse Byte
Use this command if you experience erratic movement of the mouse pointer. These can
occur when the mouse signal synchronization is lost. The command sends a null mouse byte
to the system and then automatically exits Command Mode. You may need to enter the
command a number of times to re-synchronize the mouse signal. Alternatively, stop moving
the mouse for a few seconds and the operating system’s mouse drivers may automatically
re-synchronize the signal.
Reset EQ Values +
You can use this command to zero HF & LF EQ values for the selected video channel(s).
Current color delay values are not affected.
Reset EQ & Delay Values +
Set all video EQ (HF & LF) and color delay values to zero for the currently selected video
channel(s).
You can use this command to reset EQ and delay values for both video channels in a dual-
head installation by selecting Channel 0 prior to issuing this command.
Set Extender To Default State +
Sets ALL extender settings (video & configuration) back to the factory defaults and then
exits Command Mode.