Nokia 6620 - Manual (Page 54)

Nokia 6620 User Guide 43 Copyright © 2004 Nokia
Messaging
• WRITE TEXT
You can key in text in two different ways, using the method traditionally used in
mobile phones or another method called predictive text input.
Traditional text input
When you are writing text using traditional text input, the indicator is
shown on the top right of the display.
Press a number key (1–9), repeatedly until the desired character appears. Note that
there are more characters available for a number key than are printed on the key.
Character modes— and indicate the selected case. means
that the first letter of the next word is written in upper case, and all other letters
will automatically be written in lower case.
indicates number mode.
Change between the different character cases—Press the # key to change
between the character cases Abc (
), abc ( ), and ABC ( ). Note
that if you press the # key twice quickly the predictive text input is turned on.
To switch between letter and number mode, press and hold the # key.
To insert a number, press and hold the corresponding number key.
If the next letter is located on the same key as the present one, wait until the cursor
appears (or scroll right to end the time-out period), and then key in the letter.
If you make a mistake, press the Clear key to remove a character. Press and hold
the Clear key to clear more than one character.
Insert symbols and punctuation marks—The most common punctuation marks are
available using the
* key. While in the character mode, press the * key to display
punctuation marks. Use the joystick to move through the list and press Select to
insert the character.
To insert a space, press the 0 key. To move the cursor to the next line, press the
0 key three times.
Reports (network service)—You can request the network to send you a
delivery report of the text messages, smart messages, and multimedia
messages you have sent. To turn on delivery report reception, go to the
Messaging main menu, select Options > Settings > Text message
or
Multimedia message, and select Receive report > Yes.
It might not be possible to receive a delivery report of a multimedia
message that has been sent to an e-mail address.
Before you create a multimedia message, write an e-mail, or connect to
your remote mailbox, you must have the correct connection settings in
place. See "Write and send messages" on page 46. See "Settings needed
for multimedia messaging" on page 47.