Toshiba Tecra M9 - Manual (Page 63)

User’s Manual 3-21
M9
12. Tuck the keyboard ribbon cable into the groove under the memory
module cover.
Seating the memory module cover
13. Insert the tabs on the front of the keyboard into the corresponding
notches on the computer and place the keyboard down.
14. Replace the keyboard and secure it using the two screws.
Replace the keyboard
15. Set the keyboard brace into its groove and hold down to secure the
latches.
16. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power and Power-Up Modes , for details.
17. Turn your computer over.
18. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start -> Control Panel -> System and Maintenance ->
System icon.
Memory module cover
Screws
Keyboard ribbon cable
When seating the keyboard, be sure to connect the circuit board if the
keyboard ribbon cable was pulled out while you were removing the
keyboard.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure no foreign matter can be found
inside the computer.
Keyboard
Screws
Tabs