Toshiba Magnia 550d - Manual (Page 65)

If you click the [Edit] button while the Filter Settings tab is active, the screen shown below is displayed.
You can register the condition you want to select from the Event Log.
Configure Alerts screen (Filter Settings - Edit)
Item Explanation
[Logfile] radio button
Select the type of log file.
[Event Type] check box Select the target event type(s).
Specify one or more types. At least one type must be selected.
[Event Source] edit box Specify the source name(s).
When specifying two or more sources, separate them with a comma “,”.
Wild cards (“*” and” ?”) can be used. If no source is specified, all
sources are applicable. Source name(s) can be specified with up to 128
characters.
[Event ID] edit box Specify the event ID. When specifying two or more event IDs, separate
them with a comma “,”. Up to 16 event IDs can be specified. Use a
hyphen “-” to specify a range. If no event ID is specified, all event IDs
are applicable.
[Description Keyword]
edit box
Specify the description keyword.
The keyword can be specified with up to 64 characters.
[Data Filter Bytes] edit
box
Specify the data filter bytes in hexadecimal.
Up to 64 characters of data can be specified.
[Data Filter Offset] edit
box
When specifying a data filter bytes, specify the data filter offset position in
decimal notation.
If no data offset is specified, all offsets are applicable.
Specify the “Event Merging Interval” in seconds.
[Clear] button Resets the data to their initial state.
[Set] button Sets the specified data.
[Event Merging Interval]
edit box
53