Toshiba Magnia 550d User Manual
Page 16
Fault report function
If a fault occurs in an Agent, fault information can be reported to the Management Console.
There are two ways to send a report to the Management Console:
1. Displaying an Alert Message on the Management Console
2. Sending e-mail to a designated component (Management Console or other)
Five fault levels are specified: Information, Warning, Error, Success Audit, and Failure Audit.
Events written to the event log on the Agent are reported to the Management Proxy.
These events reported by the Agent can be filtered.
(3.3.10 Configure Alerts screen)
Information on faults at the Agent that were reported to the Management Proxy can be filtered and
forwarded to the Management Console or to an e-mail destination.
(3.4.5 Alert Message Location screen)
Front panel indicator function
When the Agent is MAGNIA Z300/Z310, it enables the user to type a specified character string via
the Management Console to change the information displayed on the front panel display.
Performance display function
Displays the performance of the Agent. If threshold values are set, events will be written to
the Agent event log when either rate exceeds the specified threshold.
(3.3.1 Summary screen)
Mobile IP Software function
Displays the information about Mobile IP Software.
Please refer to User's Guide of the Mobile IP Software.
(3.3.6 Mobile IP Software screen)
Software Access Point function
Displays the information about Software Access Point.
Please refer to User's Guide of the Software Access Point.
(3.3.7 Software Access Point screen)
4