Toshiba Tecra M4 - Manual (Page 66)

TECRA M4 3-10
Getting Started
Opening the display
The computer’s LCD display panel can be rotated in a wide range of angles
for optimal viewing.
1. Push the display latch on the front of the computer to unlatch the LCD
display panel.
2. While holding down the palm rest with one hand so that the main body
is not raised, lift the panel slowly. Adjust the angle of the panel to
provide optimal clarity.
Opening the LCD display panel
Turning on the power
This section describes how to turn on the power.
The Power button LED indicates the status. Refer to the
Power indicators
section in Chapter 6, Power and Power-Up Modes.
1. Open the computer’s LCD display panel.
Use reasonable care when opening and closing the LCD display panel.
Opening it vigorously or slamming it shut could damage the computer.
Display
latch
LCD display panel
■ After you turn on the power for the first time, do not turn it off until you
have set up the operating system. Refer to the section Starting up for
the first time .
■ If the USB floppy disk drive is connected, make sure it is empty. If a
floppy disk is in the drive, press the eject button and remove the floppy
disk.