Toshiba Portege R200 (PPR20) - Manual (Page 69)

PORTÉGÉ R200 4-7
Operating Basics
Using the USB floppy disk drive
An optional USB floppy disk drive connects to the computer’s USB port.
It accommodates 1.44-megabyte or 720-kilobyte floppy disks. Refer to
Chapter 2, The Grand Tour , for more information.
Option or provided with some models.
Connecting USB floppy disk drive
To connect the drive, plug the floppy disk drive’s USB connector into one of
the computer’s USB ports.
Connecting the USB floppy disk drive
■ Avoid swiping with the finger stiff or pressed-on too hard
Fingerprint reading may fail if the center of the fingerprint is not
touching on the sensor, or when finger is swiped while pressing hard.
Make sure that the center of the fingerprint is touching the sensor
before swiping.
■ Confirm the center of the fingerprint whirl before swiping
The thumb's fingerprint has a bigger whirl, which is prone to
misalignment and distortions. This will cause difficulty in registration
and a drop in the authentication success rate. Always confirm the
center of the fingerprint whirl so that it is swiped along the centerline of
the sensor.
■ When fingerprint reading is not successful
There is a possibility of authentication failures if the finger is swiped too
quickly or too slowly. Follow the onscreen instructions to adjust the
speed of the swipe.
Make sure that the socket is at the back side and the connector is properly
aligned with the socket. Do not try to force the connection, as doing so can
damage the connecting pins.
USB connector
USB port