Toshiba Portege R200 (PPR20) - Manual (Page 162)

PORTÉGÉ R200 B-7
Display Controller and Modes
Display settings
1. You cannot move from the [Settings] tab of [Display Properties] to the
multi-monitor when you are using the display of the computer and an
external CRT display.
*The [Settings] tab is displayed in the following steps;
1) Open [Control Panel], click [Appearance and Themes].
2) Click [display].
3) Select [Settings] tab.
■ The way to move to multi-monitor
1) Press [Ctrl] + [Alt] + [F12] keys to make.
[Intel(R) 82852/82855 GM/GME Graphics Controller Prope...]
displayed.
2) Click in the left of [Devices] tab, then select [Extended Desktop].
3) Select either Monitor (CRT display) then select Apply button,
because the Primary Device is fixed into Notebook (the display of
the computer).
2. Some reproduced DVD picture may not be displayed when the display
of the computer and a CRT display are used at the same. Reduce the
resolution, use the display of the computer only, use the CRT display
only or set display device in the multi-monitor, then play DVD.
Please refer to
External monitor in this manual of Chapter 8, Optional
Devices or the application guide for the setting of each display device.
3. When playback DVD title with Multiple Monitors mode, there are some
case that DVD Overlay is not shown. In this case, please try to playback
WinDVD with decreasing resolution, refresh rate or colour depth after
exit WinDVD player.
4. There are some case that you can select non-support mode with LCD/
CRT Dual Clone mode or MultiMonitor mode. In this case, please try to
decrease CRT resolution, refresh rate or colour depth.