Toshiba Qosmio G20 (PQG20) - Manual (Page 74)

4-2 User’s Manual
Operating Basics
Using the USB floppy disk drive (optional)
An optional USB floppy disk drive connects to the computer’s USB port.
It accommodates 1.44-megabyte or 720-kilobyte floppy disks. Refer to
Chapter 2, The Grand Tour , for more information.
Connecting USB floppy disk drive
To connect the drive, plug the floppy disk drive’s USB connector into one of
the computer’s USB ports.
Connecting the USB floppy disk drive
Disconnecting USB floppy disk drive
When you have finished using the floppy disk drive, follow the procedures
below to disconnect it:
1. Wait for the indicator light to go out to make sure all floppy disk activity
has stopped.
2. Click the Safely Remove Hardware icon on the Task Bar.
3. Click the floppy disk drive device that you want remove..
4. Pull the floppy disk drive’s USB connector out of the computer’s USB
port.
Make sure the connector is right side up and properly aligned with the
socket. Do not try to force the connection; doing so can damage the
connecting pins.
USB connector
USB port
If you connect the floppy disk drive after turning on the computer, it will
take about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.
If you disconnect the floppy disk drive or turn off the power while the
computer is accessing the drive you may lose data or damage the floppy
disk or the drive.