Toshiba Tecra A4 (PTA40) - Manual (Page 170)

9-20 User’s Manual
Troubleshooting
Standby/Hibernation
LAN
A
CONNECT
display is
quickly replaced by
NO
CARRIER
Check the error control setting in your
communications application.
You can also use the AT\N command.
Character display
becomes garbled
during a
communication
In data transmission, make sure the parity bit
and stop bit settings correspond with those of
the remote computer.
Check the flow control and communication
protocol.
You cannot receive an
incoming call
Check the rings before auto answer setting in an
incoming call your communications application.
You can also use the ATS0 command.
If problems persist, contact your dealer.
Problem Procedure
The system will not
enter Standby/
Hibernation
Is Windows Media™ Player open? The system
might not enter Standby/Hibernation, if Windows
Media Player is either playing a selection or
finished playing a selection. Close Windows
Media Player before you select Standby/
Hibernation.
If problems persist, contact your dealer.
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN Make sure the AC adaptor is connected. The
does not work Wake-up on LAN function
consumes power even when the system is off.
If problems persist, consult your LAN
administrator.
Problem Procedure