Toshiba Tecra A4 (PTA40) - Manual (Page 131)

User’s Manual 7-3
HW Setup and Passwords
3. Click the OK button. If the character string you enter matches the
registered password, the password option is reset and the display
changes to:
Not registered
If they do not match, the following message appears. You must repeat
step 1.
Incorrect Password!!!
4. Follow the same procedures described in the earlier section, How to set
the password, to set a new user password.
Parallel/Printer
Some models are equipped with Parallel/Printer tab. This tab lets you set
the Printer Port Type. Use the Windows Device Manager to make settings
for the Parallel port.
Parallel Port Mode
The options in this tab are
ECP
and
Standard Bi-directional
.
Display
This tab lets you customize your computer’s display settings for either the
internal LCD screen or for an external monitor.
Power On Display
Lets you set the display to be used when the computer is booted .
If you enter the password incorrectly three times in a row, the computer
need to shut off.
You will not be able to access the password option in the HW Setup. In this
case you must turn the power off and back on to retry the procedure.
ECP
Sets the port type to Extended Capabilities Port
(ECP). For most printers, the port should be set to
ECP
. (Default)
Standard
Bi-directional
This setting should be used with some other
parallel devices.
Auto-Selected
Selects an external monitor if one is connected.
Otherwise, it selects the internal LCD. (Default)
LCD+AnalogRGB
Selects both the internal LCD and external monitor
for simultaneous display.