beautypg.com

Charging the batteries, Procedures, Charging the batteries -7 procedures -7 – Toshiba Tecra A4 (PTA40) User Manual

Page 121

background image

User’s Manual

6-7

Power and Power-Up Modes

7. Never install or remove the battery pack without first turning off the

power and disconnecting the AC adaptor. Never remove the battery

pack while the computer in Suspend or Standby mode. Data will be lost.

Note

1. Never remove the battery pack while the Wake-up on LAN function is

enabled. Data will be lost. Before you remove a battery pack, disable

the Wake-up on LAN function.

2. To ensure the battery pack maintains maximum capacity, operate the

computer on battery power once a week until the battery pack is fully

discharged. Refer to the section Extending battery life in this chapter for

procedures. If the computer is continuously operated on AC power for

an extended period, more than a week, the battery might fail to retain a

charge. It might not function efficiently over the expected life of the

battery pack and Battery indicator might not indicate a low-battery

condition.

3. After the battery pack is charged, avoid leaving the AC adaptor

connected and the computer turned off for more than a few hours at a

time. Continuing to charge a fully-charged battery pack can damage the

battery.

Charging the batteries

When the power in the battery pack becomes low, the Battery indicator

flashes amber indicating that only a few minutes of battery power remain.

If you continue to use the computer while the Battery indicator flashes, the

computer enables Hibernation mode (so you don’t lose data) and

automatically turns off.

You must recharge a battery pack when it becomes discharged.

Procedures

To recharge a battery pack while it is installed in the computer, connect the

AC adaptor to the DC IN socket and plug the other end into a working

outlet.
The Battery indicator glows amber when the battery is being charged.

The computer enters Hibernate mode only if Hibernation is enabled in two

places: the Hibernate tab in Power Options and Setup Action tab in

TOSHIBA Power Saver.

Use only the computer connected to an AC power source or charge the

battery pack. Do not attempt to charge the battery pack with any other

charger.