beautypg.com

Monitoring battery capacity, Maximizing battery operating time, Cooling method – Toshiba Tecra A4 (PTA40) User Manual

Page 123

background image

User’s Manual

6-9

Power and Power-Up Modes

Monitoring battery capacity

Remaining battery power can be monitored in TOSHIBA Power Saver.

Maximizing battery operating time

A battery’s usefulness depends on how long it can supply power on a

single charge.
How long the charge lasts in a battery depends on:

How you configure the computer (for example, whether you enable

battery-power saving options). The computer provides a battery save

mode, which can be set in TOSHIBA Power Saver, to conserve battery

power. This mode has the following options:

CPU Precessing speed

Screen brightness

Cooling Method

System standby

System Hibernation

Monitor Power off

HDD Power off

How often and how long you use the hard disk, CD/DVD-ROM drive

and the diskette drive.

How much charge the battery contained to begin with.

How you use optional devices, such as a PC card, to which the battery

supplies power.

Enabling Resume mode conserves battery power if you are frequently

turning the computer off and on.

Where you store your programs and data.

Closing the display when you are not using the keyboard saves power.

Operating time decreases at low temperatures.

The condition of the battery terminals. Make sure the battery terminals

stay clean by wiping them with a clean dry cloth before installing the

battery pack.

Wait at least 16 seconds after turning on the computer before trying to

monitor the remaining operating time. The computer needs this time to

check the battery’s remaining capacity and to calculate the remaining

operating time, based on the current power consumption rate and

remaining battery capacity. The actual remaining operating time may

differ slightly from the calculated time.

With repeated discharges and recharges, the battery’s capacity will

gradually decrease. Therefore, an often used, older battery will not

operate for as long as a new battery even when both are fully charged.

In this case, TOSHIBA Power Saver will indicate a 100% charge for

both the old and new battery, but the displayed estimated time

remaining will be shorter for the older battery.