Toshiba Tecra A3X - Manual (Page 119)

User’s Manual 7-9
HW Setup
Ending the BIOS Setup Program
Save the changes and end the program.
1. Press the End Key.
The “Are you sure? (Y/N) The changes you made will
cause the system to reboot.” message is displayed.
2. Press the Y key.
The configured settings are saved and the BIOS setup program ends.
The computer may reboot depending on the settings that were modified.
Ending the BIOS Setup Program Halfway
The configuration settings can be terminated halfway without saving any of
the changes made.
1. Press the Esc key.
The “Exit without saving? (Y/N)” message is displayed.
2. Press the Y key.
The BIOS setup program will end.
Execute-Disable Bit Capability
The configurations for the Execute-Disable Bit Capability is carried out in
the BIOS setup program.
This setting enables or disables the Execute-Disable Bit function.
The Execute-Disable Bit Capability setting is available in SYSTEM SETUP
(1/2).
Select the Execute-Disable Bit Capability to make changes. Please refer to
the operating instructions displayed in the settings screen.
Available Make the Execute-Disable Bit Capability usable
(Available).
Not Available Disable the Execute-Disable Bit Capability (Not
Available) (Default).
System configuration changes other than changes to this setting should be
made in Windows using TOSHIBA HW Setup, TOSHIBA Password
Utility, TOSHIBA Power Saver, Device Manager, etc.