beautypg.com

Starting and ending the bios setup program, Starting and ending the bios setup program -8 – Toshiba Tecra A3X User Manual

Page 118

background image

User’s Manual

7-8

HW Setup

USB-FDD Legacy Emulation

Use this option to enable or disable USB-FDD Legacy Emulation.

Starting and Ending the BIOS Setup Program

Starting the BIOS Setup Program

1. Switch on your computer while pressing the Esc key.

If “Password =” is displayed, enter the user password and press the

Enter key.

Please refer to the

TOSHIBA Password Utility

in Chapter 6,

Power

for

details about the user password.
The “Check system. Then press [F1] key.” message is

displayed.

2. Press the F1 key.

The BIOS setup program will start up.

Enabled

Enables the USB KB/Mouse Legacy Emulation.

(Default)

Disabled

Disables the USB KB/Mouse Legacy Emulation.

Enabled

Enables the USB-FDD Legacy Emulation.

(Default)

Disabled

Disables the USB-FDD Legacy Emulation.

Notes before using the BIOS Setup

In normal cases, changes in system configuration should be made in

Windows using TOSHIBA HW Setup, TOSHIBA Password Utility,

TOSHIBA Power Saver, Device Manager, etc.

If the configuration in the BIOS setup program is different from the

configuration in the Windows utility, the configuration in the Windows

utility takes priority.

Depending on the system, changes made to the system configuration

might not be reflected.

The settings in the BIOS setup program are not erased even if the

power supply is switched off. However, if the built-in battery (RTC

battery) runs out of power, the settings will revert back to their default

values.

The following item does not revert back to their default values.

Password

HDD Password

Security controller