Xerox DocuColor 242-252-260 con built-in Fiery controller-16191 - Manual (Page 33)

Page 33
Command
WorkStation Command WorkStation Macintosh Edition, multiple server access
Command WorkStation, Macintosh Edition is designed for the graphic arts user in a single
server environment. Using Command WorkStation, Macintosh Edition, you cannot access
multiple Fiery servers simultaneously (however, simultaneous access is possible using
Command WorkStation, Windows Edition, which is designed for a production printing
environment).
Job size
Command WorkStation displays job size in kilobytes, regardless of the size of the file.
Other tools may show job size in megabytes or kilobytes.
Job Log
Save and clear the Job Log regularly. After the Job Log accumulates a large number of
entries (approximately 16,000 jobs), the Fiery stops responding when you start Command
WorkStation.
Activity Monitor
When you print more than one copy of a job, the Activity Monitor reports that Copy 2
is printing, and then Copy 2, Copy 3, Copy 4, and so on. Although the Activity Monitor
does not start counting with Copy 1, the correct number of copies prints.
Available memory
The General Info section displays the amount of memory available for Command
WorkStation and other Fiery software, whereas the Configuration page displays the amount
of memory available for Command WorkStation, other Fiery software, and the Fiery system
software.
N OTE : The “Memory 100%” displayed in the upper-right corner of the copier display is the
copier memory. The memory bar in Command WorkStation is the Fiery Color Server
memory.
Combine Separations
If you send a job with Combine Separations set to On, you may see an error message
in Command WorkStation. To avoid the error message, set Combine Separations to Off,
or send a Separations job.
Offset values not in Impose template
When you save a template in Impose, the X and Y offset values are not saved.