Xerox DocuColor 242-252-260 con built-in Fiery controller-16191 - Manual (Page 10)

Page 10
Date and time stamps for jobs
N OTE : You should set the time and date on the Fiery Color Server, which will control the time
and date on copier.
You can print the following reports:
• Job Status
• Scan Mode Settings
• Copy Mode Settings
• Network Controller Jobs Report
All jobs in Job Status, Scan Mode Settings, and Copy Mode Settings use the date and time
on the copier.
You can print the following reports from Network Controller Jobs Report:
• Job History Report
• Error History Report
• Fonts List
• System Settings List
The Job History Report, Fonts List, and System Settings List use the date and time on the
Fiery Color Server. The Error History Report uses the date and time on the copier (except for
error codes from the Fiery Color Server).
Time Server IP/Name
When you specify “pool.ntp.org” from the copier touch panel(Setup > General > Time
server), the Configuration displays “World” as the Time Server IP/Name., which is correct for
pool.ntp.org (the Worldwide time server). All the other settings are regional.
Daylight Savings Time
In WebTools, the option to automatically adjust the clock for daylight saving time appears
grayed-out, however, the option functions and is automatically enabled.
On the copier touch panel, there is no Daylight Savings Time option. The Daylight Savings
Time adjustment is automatically enabled in WebTools.