Xerox WIDE FORMAT AccXES Firmware 10.0 b140 (Release Notes) - Manual (Page 17)

Page 17
there can be scan errors; when there are fewer jobs in the queue, the jobs can then be
resubmitted or scanned. Additionally, completed jobs will be removed from the queue display
immediately to make room for the newly submitted print jobs. To avoid these issues, keep the
number of active print jobs to under the 128 limit.
NOTE: More than 128 files can be sent from the Document Submit Tool as one print job, but all of
the files in the print job must have printed before sending subsequent jobs, or the jobs will be
refused.
7.6.2 Backlit-Film media type
If you are using the Backlit-Film-360 media type in your printer, WebPMT lists it as Backlit-Film-
360/720 to accommodate legacy versions of AccXES. If you select Backlit-Film-360/720 as the
media type in WebPMT, you must have the Backlit-Film-360 media loaded in the printer and
identified as Backlit-Film-360 at the printer, or you will create a mismatch. If you are using the
Backlit-Film-720 media type, both the printer and WebPMT will list it as Backlit-Film-720.
7.6.3 Netscape 6.1 users only
It is recommended to use Netscape 7.0 or newer.
• Netscape 6.1 does not support the adjusting of the color graph settings for the
POLY_CLOTH_360 media. This is located on the Web PMT. Select PRINTER DEFAULTS >
PROCESSING DEFAULTS > Media > Media Specific Settings drop down list. Choose
POLY_CLOTH_360. Select the Adjust Settings (Graphical UI) button. When you adjust the
color graph lines, the changes will not be saved when you apply the Update Printer button.
• When Netscape 6.1 is used, the pen patterns do not appear to load correctly, and the
browser exhibits erroneous behavior. However, if the Stop (browser) button is pressed and
the patterns page is viewed, the new pen pattern will appear as expected.
• HTML code may appear on the Media page after pressing the Update Printer button, when
Netscape 6.1 is used. The changes will, however, be kept.
7.6.4 Netscape 7.0 users only
A “Document contains no data” message may appear on the Main WebPMT page after rebooting
the printer and pressing the Get Status button. If so, click the OK button on the message box and
again select the Get Status button.
7.6.5 German users only
Zum Drucken von Etiketten mit Umlauten DRUCKERVORGABEN > DRUCKER-EINSTELLUNG
> Plot-Etiketten wählen.
Anschließend im Dropdown-Menü für Fonts einen der folgenden Fonts wählen: HP2 Stick Font
Latin - 1 oder HP2 Stick font Latin - 1 – Proportional.
7.6.6 Large Scaling Factors
Images set to scale beyond the largest installed roll will not scale beyond the largest width unless
a specific roll is selected, a specific page size is selected, or mismatch mode is set to something
other than scaling. This is a behavior that has changed from previous releases (prior to 9.0).
For example: The largest roll installed is 36". Scaling is set to 999%. Submit an ARCH E sized
drawing (Media Size = Any, Mismatch = Scaling). The drawing will not be scaled.
In order for the output to exhibit the desired scaling factor, one of the following conditions must be
met: