Xerox WIDE FORMAT AccXES Firmware 10.0 b140 (Release Notes) - Manual (Page 13)

Page 13
7 Release Notes
The following information supplements the 10.0 customer user guides.
7.1 Controller
7.1.1 HFT and KLF Controller on the Xerox Wide Format Print
System X2 TECH Rebooting procedure
When the Controller is rebooted, the X2 TECH printer must also be rebooted. This is due to
communication along the SCSI chain. If the controller is in the middle of a SCSI command at the
time it is rebooted, the printer no longer communicates.
Note that the proper power on sequence for a Xerox Wide Format Print System X2 TECH is X2
TECH printer, then scanner (if so equipped), then Controller.
7.1.2 Firmware Installation of a Device Failed
If a firmware installation fails, repeat the installation procedure. Occasionally, other events may
interrupt the firmware installation on the AccXES controller.
7.1.3 AccXES firmware 7.5 or earlier
When upgrading to, or downgrading from AccXES revisions 7.5 or earlier, the time and date may
be erroneously changed. To check and/or reset this go select Printer Defaults > Printer Setup >
Date/Time.
7.1.4 Stamp does not appear
If the user tries to upload a stamp files that contains an invalid format, or if the Accounting Mode
is set to “Enabled”, no error message will be displayed. The Web PMT screen will display a
message that the file was uploaded successfully and the stamp’s filename will not appear in the
“Printer Resident Stamps” list. To avoid this situation, set the Job Accounting mode to “Optional”.
The Web PMT has no knowledge of the validity of any file that is sent to the printer. File validation
and error handling is done on the printer by the AccXES controller. The Web PMT only reports
that the file was sent to the printer successfully.
7.1.5 Scaling interaction with “ANY”
The media size “ANY” will select the best sheet size for an image to prevent clipping. If a user
specifies a media size of “ANY” and a scale factor that makes the image too large for any sheet
size and mismatch mode is set to scale, the controller will select the largest sheet size and scale
the image to fit on it.
If this is not the desired behavior, a specific sheet size can be selected, or the media mismatch
mode can be set to QUERY.