Konica Minolta bizhub PRESS C1100 - Manual (Page 55)

5-10
bizhub PRESS C1100/C1085
5
D
Press [Front] or [Back] to select the print
side to be adjusted.
E
Enter the zoom ratio or the image shift value using the keypad, [,], or [+] on the
screen or the Keypad on the control panel.
- To specify the zoom ratio, press [Vertical] or [Horizontal], then enter a value.
[Vertical] is used to adjust the zoom ratio in the crosswise direction.
[Horizontal] is used to adjust the zoom ratio in the paper feed direction.
To enlarge the print side, enter the value with a positive mark (+). To reduce it, enter the value with
a negative mark (-).
The adjustment value changes 0.01% on a 1-step basis.
Adjustment Range: [Vertical] -1.00 to +1.00, [Horizontal] -1.00 to +1.00
*
* [Horizontal] of [Back] must be specified between -0.80 and +0.20.
- When not adjusting [Horizontal] of [Back], select [User Setting] - [Common Setting], then set [Back
Side Magnification Adj.] to [OFF]. For details, refer to the HTML User's Guide.
- To move the print side upward, downward, leftward, or rightward (image shift), press [Up/Down] or
[Right/Left], then enter the value.
To move the print side upward or rightward, enter the value with a positive mark (+). To move the
print side downward or leftward, enter the value with a negative mark (-).
The adjustment value changes 0.1 mm on a 1-step basis.
Adjustment range: [Up/Down] -10.0 to +10.0, [Right/Left] -3.0 to +3.0
- To switch the positive mark (+) and negative mark (-), press [+/-].
- To reset a value, press [Clear].
- To adjust the zoom ratio and image shift, check the status in the center of a page.