Konica Minolta bizhub PRESS C1100 - Manual (Page 47)

5-2
bizhub PRESS C1100/C1085
5
Making the Both Sides Adjustment for each tray
Adjust a misalignment between the front and back sides, which is caused during the duplex printing, for each tray.
The following two methods are available to carry out the Both Sides Adjustment.
- Chart Adjustment
- Zoom and Image Shift Adjustment
Tips
You can register Both Sides Adjustment values in a paper profile with paper conditions specified. If paper conditions
are registered, you can carry out printing under the previous conditions even when you have changed a tray to load
paper into. For information about how to edit or register a paper profile, refer to the HTML User's Guide.
) Chart Adjustment
You can print out a Both Sides Adjustment chart, measure measurement points using a scale, and enter measurement
values in order to carry out the adjustment.
Using this function, you can only enter measurement values to carry out the both-side adjustment. This is convenient
when an unclear misalignment is detected between the front and back sides to perform the duplex printing with a new
type of paper or to change paper in a tray.
A
Press [Paper Setting] on the [MACHINE]
screen.
B
Select the tray with the target paper
loaded, then press [Change Set].