Konica Minolta bizhub PRESS C1100 - Manual (Page 13)

1-3
bizhub PRESS C1100/C1085
1
) Power saving function
Using the following functions can reduce the power consumption of this machine and provide greater power saving
effects.
Tips
- Since Utility/Counter - [Administrator Setting] - [System Setting] - [Power Save Setting] - [Power Save Function
Setting] is the same as Utility/Counter - [User Setting] - [System Setting] - [Power Save Setting] - [Power Save
Function Setting], use either of the methods to configure a setting.
- If Power Save on the control panel is pressed for one second or more, either of Auto Low Power or Auto Shut
OFF is enabled. To enable either function, select [Administrator Setting] - [System Setting] - [Power Save Setting]
- [Power Save Function Setting].
Reference
For details about how to configure and use the above functions, refer to the HTML User's Guide.
NOTICE
NOTICE
In the Auto Shut OFF mode, only jobs from [PageScope Direct Print (PSDP)] can be printed out. To use other jobs,
check that this machine can be used normally.
If this machine is turned off because the Weekly Timer has started, job data is not received even if it is sent. While this
machine can be used normally, send job data again.
Function Description
Power Save func-
tion Auto Low Power Turns off the touch panel display to reduce the power consumption
of this machine. This machine is placed into the Auto Low Power
mode when:
•
The specified period of time has elapsed with no print jobs exe-
cuted in the printable state
• Power Save on the control panel has been pressed for a sec-
ond or more
This mode is available when [Auto Low Power] is selected by select-
ing Utility/Counter - [Administrator Setting] - [System Setting] -
[Power Save Setting] - [Power Save Function Setting].
There are eight power saving time periods available: 5 min., 10 min.,
15 min., 30 min., 60 min., 90 min., 120 min. and 240 min., from which
you can select the desired one.
Auto Shut OFF Turns off all LEDs except Power Save and Power LED on the con-
trol panel, to reduce the power consumption of this machine. This
machine is placed into the Auto Shut OFF mode when:
•
The specified period of time has elapsed with no print jobs exe-
cuted in the printable state
• Power Save on the control panel has been pressed for a sec-
ond or more
If the Auto Shut OFF mode is kept for a long time, it may take a while
to warm up this machine upon restart.
This mode is available when [Auto Shut OFF] is selected by selecting
Utility/Counter - [Administrator Setting] - [System Setting] - [Power
Save Setting] - [Power Save Function Setting].
There are seven power saving time periods available: 0 min., 1 min.,
30 min., 60 min., 90 min., 120 min. and 240 min., from which you can
select the desired one.
ErP Setting Turns the main power off after the Auto Low Power mode, Auto Shut
OFF mode, or the sub power switch is kept in the off state for the
specified period of time.
There are seven power-saving time periods available: Do Not
Switch, 12 Hours, 24 Hours, 36 Hours, 48 Hours, 60 Hours and 72
Hours, from which you can select the desired one.
If the Weekly Timer is set to [Weekly Timer ON], [ErP Setting] ap-
pears dimmed and you will not be able to configure this setting.
Weekly Timer Automatically turns the power of this machine on or off based on the
specified time or day of the week.