Konica Minolta bizhub C550 - Manual (Page 346)

Appendix 8
C550 8-2
8 Appendix
8.1 Error message list
If any of the following error messages appear, perform the operations de-
scribed below.
2
Note
For details on the network settings, refer to the User’s Guide [Network
Scanner Operations].
Message Cause and remedy
Cannot connect to the
network. A connection to the network could not be established. Check if the
network cable is correctly connected. In addition, check that the Net-
work Setting parameters on the Administrator mode have been cor-
rectly specified.
The destination cannot
be selected because the
number of destinations
has exceeded the max.
number of broadcasting
possible. The number of destinations specified exceeds the number possible
for a broadcast transmission. Reduce the number of broadcast des-
tinations, or send the transmission in multiple batches.
Image could not be
saved in the User Box
due to insufficient HDD
capacity check log. The hard disk is full. Delete unnecessary data, and then try saving the
data again.
The number of User Box-
es has reached its maxi-
mum. The number of user boxes that can be registered has reached the
maximum number possible. Delete unnecessary user boxes, and
then try registering new boxes again.
This user box has
reached its maximum
number of documents
allowed. The number of documents that can be saved in a user box has
reached the maximum number possible. Delete unnecessary docu-
ments, and then try saving the document again.
The number of pro-
grammed jobs has
reached the max. allow-
ance.
Wait until a programmed
job is completed. The number of jobs that can be programmed has reached the maxi-
mum number possible. Wait until a job has been completed, or de-
lete a current job.