beautypg.com

Printing – Konica Minolta magicolor plus User Manual

Page 20

background image

E-20

Press the Color

button and select Color or Black & White.

Press the Print

button to print.

• The reading operation is performed for a one-sheet portion (while the sheet is scrolled) and the printing operation is

performed.

• If the ON/Standby

button is pressed while the sheet surface is being read, printing is interrupted and only

part of the image will be printed.

To move the sheet surface, wait until scrolling stops, then press the Feed

button.

• When a USB memory has been inserted, a press of the Save

button during printing will start the USB mem-

ory storage operation after printing is completed. (See Page E-23.)

• The one-screen portion is reduced to A4 paper size and printed.
For wide type Captureboards (model C-12W), the image is compressed about 75% in the horizontal direction. To print

with the same proportions as the image on the sheet surface, see “Printing in the same ratio as the sheet surface” (page
E-22).

• A flashing “

” in the display window indicates a print error. See “Meaning of Error Messages” on Page E-32.

• While scrolling, a moving hole will be visible at the bottom of the sheet; however, this is a required hole accord-

ing to the specifications and is not damage.

• When the sheet is moving, buckling of the sheet may be observed; however, this is not a fault.

When the Captureboard is not going to be used, press the ON/Standby

button and switch

off the power (standby mode).

• Switch off the printer power.

When the Erase Reminder function is set to "Enable

"

When the ON/Standby button is pressed, the display window and all the indicators flash

simultaneously, the sheet automatically moves to the surface that is not yet erased and
the power turns off.

* The Erase Reminder function may not work properly due to dirt on the sheet's adhesive

sections or marker residue.

• If no button is operated for 30 minutes or greater, the unit is set to the sleep mode and the LEDs on the control

panel turn off. If the ON/Standby

button is pressed, the LEDs on the display window turn on. If the print but-

ton

is pressed at this time, the printing operation starts.

Color mode lamp
Lit

Printing will be in color.

Unlit

Printing will be in black & white.

Printing

Note

Display window

Note