Lenovo ThinkServer TD200x User Manual
Page 98
– On models with eight hard disk drives, the top bays are numbered 0 through 7
(from right to left)
– On models with 16 hard disk drives, the top bays are numbered 0 through 7
(from right to left) and the bottom bays are 8 through 15 (from right to left)
0
Bay 0
8
Bay 8
1
Bay 1
9
Bay 9
2
Bay 2
10
Bay 10
3
Bay 3
11
Bay 11
4
Bay 4
12
Bay 12
5
Bay 5
13
Bay 13
6
Bay 6
14
Bay 14
7
Bay 7
15
Bay 15
v
For a list of supported optional devices for the server, see
v
Inspect the drive and drive bay for signs of damage.
v
Make sure that the drive is correctly installed in the drive bay.
v
See the documentation for the ServeRAID controller for instructions for installing
a hard disk drive.
v
All hot-swap drives in the server must have the same throughput speed rating;
using drives with different speed ratings might cause all drives to operate at the
throughput of the slowest drive.
v
You do not have to turn off the server to install hot-swap drives in the hot-swap
drive bays. However, you must turn off the server when you perform any steps
that involve installing or removing cables.
v
The drive ID for each hot-swap hard disk drive is printed above the drive bay.
82
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Installation and User Guide