beautypg.com

Lenovo THINKSERVER TD230 User Manual

Page 47

background image

7. Slide the new optical drive into the drive bay until it snaps into position.

Figure 23. Installing the optical drive

8. Connect one end of the signal cable

2

to the rear of the new optical drive and the other end to an

available SATA connector (SATA connector 5 recommended) on the system board. See “Locating
parts on the system board” on page 15.
Then, locate an available five-wire power connector

1

and

connect it to the rear of the new optical drive.

Figure 24. Connecting the optical drive cables

Chapter 5

.

Installing, removing, or replacing hardware

37