beautypg.com

Creating integrated striping volumes – MSI X2-109 v2 User Manual

Page 121

background image

B-19

LSI SAS RAID

5. Creating Integrated Striping Volumes

This section describes how to create Integrated Striping (IS) volumes using the LSI

Logic SAS BIOS Configuration Utility (SAS BIOS CU).

5.1 IS Configuration Overview

You can use the SAS BIOS CU to create multiple IS volumes, with up to 10 drives total

on an LSI Logic SAS controller. Each volume can have from 2 to 8 drives. Disks in an

IS volume must be connected to the same LSI Logic SAS controller, and the controller

must be in the BIOS boot order.

Although you can use disks of different size in IS volumes, the smallest disk deter-

mines the “logical” size of each disk in the volume. In other words, the excess space

of the larger member disk is not used. Usable disk space for each disk in an IS volume

is adjusted down to leave room for metadata. Usable disk space may be further

reduced to maximize the ability to interchange disks in the same size classification.

The supported stripe size is 64 Kbytes.

Refer to Section 4.2, “IS Features,” for more information about Integrated Striping

volumes.

5.2 Creating IS Volumes

The SAS BIOS CU is part of the Fusion-MPT BIOS. When the BIOS loads during boot

and you see the message about the Setup Utility, press Ctrl-C to start it. After you do

this, the message changes to:

Please wait, invoking SAS Configuration Utility...

After a brief pause, the main menu of the SAS BIOS CU appears. On some systems,

however, the following message appears next:

LSI Logic Configuration U tility will load following initialization!

In this case, the SAS BIOS CU will load after the system has completed its power-on

self test.

Follow the steps below to configure an Integrated Striping (IS) volume with the SAS

BIOS CU. The procedure assumes that the required controller(s) and disks are al-

ready installed in the computer system. You can configure both IM and IS volumes on

the same SAS controller.

1. On the Adapter List screen of the SAS BIOS CU, use the arrow keys to select

a SAS adapter.

9265v1.0-B(LSI SAS RAID).p65

2008/5/15, 上午 11:44

19

PDF created with pdfFactory Pro trial version

www.pdffactory.com