WIKA CPH62I0 - Manual (Page 31)

31 WIKA operating instructions, model CPH62I0
11221801.02 02/2011 GB/D/F/E
GB
6. Commissioning, operation / 7. Maintenance, cleaning ...
6.6 Available pressure sensors
The instrument has been designed so that all model CPT62I0 pressure sensors can be
connected without the need for any configuration or recalibration. A wide range of inter-
changeable sensors is therefore available, with ranges of up to 1000 bar (see current
price list for model CPT62I0 pressure sensors).
7. Maintenance, cleaning and servicing (recalibration)
7.1 Maintenance
The hand-held pressure indicator CPH62I0 is maintenance-free.
Repairs must only be carried out by the manufacturer. This does not apply to the battery
replacement.
The safety of the operator may be endangered if, for example:
■ there is visible damage to the instrument.
■ the instrument is not working as specified.
■ the instrument has been stored under unsuitable conditions for an extended period of
time.
If there is any doubt, please return the instrument to the manufacturer for repair or
maintenance.
7.2 Cleaning
CAUTION!
■ Before cleaning, correctly disconnect the hand-held pressure
indicator from the pressure supply, switch it off and disconnect it
from the mains.
■ Clean the hand-held pressure indicator with a moist cloth.
■ Electrical connections must not come into contact with moisture.
■ Wash or clean the dismounted hand-held pressure indicator or
pressure sensor before returning it, in order to protect persons and
the environment from exposure to residual media.
■ Residual media in dismounted hand-held pressure indicators or
pressure sensor can result in a risk to persons, the environment and
equipment. Take sufficient precautionary measures.
For information on returning the hand-held pressure indicator see
chapter “9.2 Return”.