WIKA CPH62I0 - Manual (Page 18)

18 WIKA operating instructions, model CPH62I0
11221801.02 02/2011 GB/D/F/E
GB
6. Commissioning, operation
1
2
3
4
5
5
6. Commissioning, operation
6.1 Operator panel and basic operation
On turning the device on, if the logger function is selected, the integrated clock‘s time
will be displayed briefly. If a zero point adjustment has been carried out, the display will
indicate this by showing “nuLL-Corr”.
After changing the battery the menu for setting the clock is activated automatically
(‘CLOC’). Check the clock and adjust if necessary (see chapter “6.3.11 (CLOC) Real
time clock“).
1. ON/OFF
2. SET/MENU: Enter configuration menu
3. TARA: Activate tare function, zero point adjustment
4. STORE/QUIT: Activate hold function or logger function
(see chapter “6.4 Operation of logger”)
5. MIN/MAX: Display the respective min-/max-memory value
Max-Function: Pressing ´MAX´ shows the maximum measured value recorded.
Pressing it again hides it. To clear the max-memory press the ´MAX´
key for > 2 seconds.
Min-Function: Pressing ´MIN´ shows the minimum measured value recorded. Press-
ing it again hides it. To clear the min-memory press the ´MIN´ key for >
2 seconds.
Hold-Function: By pressing ´STORE/QUIT´ the instantaneous measured value will
be shown in the lower display. Pressing it again hides it. (Only when
logger = ‘off‘ is selected in the main menu).
Logger-Functions: Activated by the ´STORE/QUIT´ key, only if the logger has been
selected via the main menu (see chapter “6.4 Operation of logger”).
Tare-Function: By pressing ´TARA´, the display will be set to 0. All measurements
from then on will be displayed relative to the set tare value. When the
tare function is activated, the arrow ´TARA´ appears in the display. To
deactivate the tare function press ´TARA´ for > 2 seconds.