WIKA CPH62I0 - Manual (Page 27)

27 WIKA operating instructions, model CPH62I0
11221801.02 02/2011 GB/D/F/E
GB
6. Commissioning, operation
clear all data points clear nothing (cancel menu)
clear the last data point
Use the ´MIN´ or the ´MAX´ key to display the required option. The ´STORE/QUIT´ key
selects that choice.
If the logger memory is full, the display will show:
6.4.1 “Func-Stor“: Storing discrete measurements
In this mode, each time the ´Store/Quit´ key is pressed a measurement and its time
stamp will be recorded. The data recorded can be viewed either on the display (an
additional menu item “REAd-LoGG“ is displayed when scrolling through the configura-
tion menu) or through the serial interface and a PC running the GSoft software.
Max. number of measurements: 99
The data recorded includes the following values:
■ Sensor 1: instantaneous value at that data point
■ Sensor 1: Min-Peak, Max-Peak since last data point
■ Sensor 2*: instantaneous value at that data point
■ Sensor 2*: Min-Peak, Max-Peak since last data point
■ Instantaneous difference (Sensor 1 - Sensor 2)*: at that data point
■ Min-Peak, Max-Peak of the difference (Sensor 1 - Sensor 2)*: Min-Peak, Max-Peak
since last data point
■ Time and date stamp of that data point
* Only for 2-channel version CPH62I0-S2
After each recording “St. XX“ will be displayed for a short time. XX represents the
number of the data point.
If the logger memory already contains data:
When the ´STORE/QUIT´ key is pressed for 2 seconds, the option to clear the logger
memory will be displayed: