14 kramer protocol, 1 switching protocols, 1 switching protocols via the front panel buttons – Kramer Electronics VP-8x8AK User Manual
Page 44: 2 switching protocols via protocol commands, Kramer protocol, Switching protocols, Switching protocols via the front panel buttons, Switching protocols via protocol commands
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Kramer Protocol
40
14 Kramer Protocol
By default, the VP-8x8AK is set to protocol 3000 (see
) but is
also compatible with Kramer’s Protocol 2000
1
(see
).
describes how to switch between protocol 3000 and protocol
2000.
14.1
Switching Protocols
You can switch protocols either via the front panel buttons (see
) or the protocol commands (see
14.1.1
Switching Protocols via the Front Panel Buttons
To switch from protocol 3000 to protocol 2000, press and hold
2
the OUT 1
and OUT 2 buttons for a few seconds.
The display shows 2000.
To switch from protocol 2000 to protocol 3000, press and hold the OUT 1
and OUT 3 buttons for a few seconds.
The display shows 3000.
14.1.2
Switching Protocols via Protocol Commands
To switch from protocol 3000 to protocol 2000, send the following command:
#P2000
To switch from protocol 2000 to protocol 3000, send the following command:
0x38, 0x80, 0x83, 0x81
The Windows®-based Kramer control software
3
operates with protocol 2000. If
the VP-8x8AK is set to protocol 3000, it is automatically switched to protocol
2000.
1 You can download our user-friendly “Software for Calculating Hex Codes for Protocol 2000” from the technical support
section on our Web site at:
http://www.kramerelectronics.com
2 Not as part of a switching operation
3 Download the latest software from our Web site at
http://www.kramerelectronics.com