Table 1 – Kramer Electronics VP-8x8AK User Manual
Page 11
Your VP-8x8AK 8x8 VGA / UXGA / Audio Matrix Switcher
7
7
Table 1: Front Panel VP-8x8AK 8x8 VGA / UXGA / Audio Matrix Switcher Features
#
Feature
Function
1
IR Receiver
The yellow LED is illuminated when receiving signals from the infrared
remote control transmitter
2
POWER LED
The green LED is illuminated when the unit is turned ON
3
SELECTOR OUT
Buttons
Select the output
1
to which the input is switched
4
SELECTOR IN
Buttons
Select the input
to switch to the output (after selecting an output).
When a signal is detected at an input connector, the corresponding input
button is illuminated
5
ALL Button
Pressing ALL followed by an INPUT button, connects that input to all outputs
2
6
OFF Button
Press an OUT SELECTOR button and then an OFF button to disconnect that
output from the inputs.
Press the ALL button and then the OFF button to disconnect all the outputs
7
VIDEO Button
When pressed
3
actions relate to video. Press the VIDEO button together
with the AUDIO button to set the Switching delay time (see
8
AUDIO Button
When pressed
4
actions relate to audio. Press the VIDEO button together
with the AUDIO button to set the Switching delay time (see
9
AFV Button
When pressed, the audio channels follow the video channels. The button is
illuminated when the AFV mode is selected
10 STO (Store) Button
Pressing STO followed by an input/output button stores the current setting
5
.
Press the RCL button together with the STO button to set the machine
number (see
11 RCL (Recall) Button
Pressing the RCL button and the corresponding IN/OUT button recalls a setup
from the non-volatile memory.
Press the RCL button again to implement the new status.
Press the RCL button together with the STO button to set the machine
number (see
12 TAKE Button
Pressing TAKE toggles the mode between the Confirm mode
6
and the At Once
mode (user confirmation per action is unnecessary). When in Confirm mode,
pressing the TAKE button will implement a pending configuration
13 AUDIO
LEVEL
- Button
Press to decrease the input or output audio signal level
14
+ Button
Press to increase the input or output audio signal level
15 LOCK Button
Disengages the front panel switches
16 STATUS 7-segment
display
Displays the selected INPUT switched to the OUTPUT (marked above each
input)
7
17 REL. AUDIO LEVEL
7-segment display
Displays
8
the relative
9
audio level
10
1 From 1 to 8
2 For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs
3 The VIDEO button is illuminated when in breakaway mode and actions relate to video
4 The AUDIO button is illuminated when in breakaway mode and actions relate to audio
5 For example, press STO and then the output button # 3 to store in Setup # 3, or the input button 4 to store in Setup 12
6 When in the Confirm mode, the TAKE button illuminates
7 Also displays the number of INPUT and OUTPUT ports, the firmware version number, and the MACHINE #. Refer to
Section 7.2.1
8 A dot following the number, represents a value of 0.5. For example, 3.5 displays as "3."
9 The audio level range is relative, since the audio input signal can be adjusted separately via trimmers on the rear panel
10 The input audio level ranges from -100dB to +20dB and the output audio level ranges from -100dB to +7.5dB