Kramer Electronics VP-8x8AK - Manual (Page 28)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VP-8x8AK
24
7.6 Choosing the Audio-Follow-Video or Breakaway Option
You can switch stereo audio signals in one of two ways, either:
• Audio-follow-video (AFV), in which all operations relate to both the
video and the audio channels; or
• Breakaway, in which video and audio channels switch independently
7.6.1 Setting the Audio-Follow-Video Option
To set the Audio-follow-video (AFV) option, press the AFV button:
• If the AUDIO and VIDEO configurations are the same, then the AFV
button illuminates. The audio follows the video.
• If the AUDIO differs from the VIDEO, then the TAKE and the AUDIO
buttons flash. Also, the audio outputs, which are changed, flash
1
in the
INPUT STATUS 7-segment display. Press the TAKE button to confirm
the modification. The audio follows the video.
7.6.2 Setting the Breakaway Option
To set the Breakaway option:
Press either the AUDIO (for audio control only) or the VIDEO (for video
control only) button:
• If the AUDIO button illuminates, switching operations relate to Audio,
and the 7-segment display shows the audio status
• If the VIDEO button illuminates, switching operations relate to Video,
and the 7-segment display shows the video status
7.7 The Audio Input/Output Gain Control
The audio output
2
signal gain is activated when the machine is in the AUDIO
or AFV mode.
To increase or decrease the audio gain:
1. Select the output whose audio gain you want to change.
For example, press OUT 4.
The OUT 4 button blinks and so does the respective input on the display.
2. Press the + or – button to increase or decrease, respectively, the audio
gain of the selected output.
The audio gain display lights and the audio level value shows on the
display.
1 Warning that you are about to modify the audio configuration for AFV operation
2 In this section, the output also refers to the input