Kramer Electronics VP-31KSi - Manual (Page 39)

Kramer Protocol
35
Chaining Multiple
commands*
#AV 1>* | V 3>4, 2>2, 82>1, 0>2 |V 82>3| A 0>1 | V? * CR
First switch all Audio and video outputs from input 1,
Then switch video input 3 to output 4, video input 2 to output 2,
video input and disconnect video output 2.
Then switch audio input 3 to output 2,
Then disconnect audio output 1.
Then get status of all links (assume this is 4x4 matrix).
Commands processing start after entering
CR, response will sent for
each command after processing it.
~AV 1>* OK CRLF
~VID 1>2, 3>4
OK CRLF
~VID 82>3 ERR###
CRLF
~AUD 0>1 OK CRLF
~V 1>1, 0>2, 1>3, 3>4
CRLF
Signal Status commands
Command Syntax Response
Change signal status
-------------------
SIGNAL INPUT, STATUS
Get signal status SIGNAL? INPUT SIGNAL INPUT, STATUS
Parameters Description:
INPUT = Input number, ‘*’ for all.
STATUS = Signal state:
"0" or "off" for not existent signal.
"1" or "on" for existent signal.
Preset commands
Command Syntax Response
Store current
connections to preset
PRST-STO PRESET
Short form: PSTO PRESET PRST-STO PRESET RESULT
Recall saved preset PRST-RCL PRESET
Short form: PRCL PRESET PRST-RCL PRESET RESULT
Delete saved preset PRST-DEL PRESET
Short form: PDEL PRESET PRST-DEL PRESET RESULT
Read video connections
from saved preset
PRST-VID? PRESET,OUT
Short form: PVID? PRESET,OUT
PRST-VID? PRESET, * PRST-VID PRESET, IN>OUT
PRST-VID PRESET, IN>1, IN>2,…
Read audio connections
from saved preset
PRST-AUD? PRESET,OUT
Short form: PAUD? PRESET,OUT
PRST-AUD? PRESET, * PRST-AUD PRESET: IN>OUT
PRST-AUD PRESET: IN>1, IN>2,…
Read saved presets list PRST-LST?
Short form: PLST?
PRST-LST PRESET, PRESET, …
Parameters Description:
PRESET = Preset number.
OUT = Output in preset to show for, '*' for all.
Examples:
Store current Audio & Video
connections to preset 5
#PRST-STR 5 CR ~PRST-STR 5 OK CRLF