1 switching to breakaway mode, 2 switching to audio-follow-video mode, 3 setting the audio output gain – Kramer Electronics VP-31KSi User Manual
Page 23: 4 reading and writing the edid, 7 operating the vp-31ksi remotely, Switching to breakaway mode, Switching to audio-follow-video mode, Setting the audio output gain, Reading and writing the edid, Operating the vp-31ksi remotely
Operating the VP-31KSi Remotely
19
6.2.1 Switching to Breakaway Mode
To switch to breakaway mode:
•
Press either the VIDEO button or the AUDIO button.
If the VIDEO button lights, the switching relates only to video (and the
audio selection remains unchanged). If the AUDIO button lights, the
switching relates only to audio (and the video selection remains unchanged)
6.2.2 Switching to Audio-Follow-Video Mode
To switch to Audio-Follow-Video mode:
•
Press the VIDEO and the AUDIO buttons simultaneously.
Both VIDEO and AUDIO buttons light red and the audio channel will
immediately switch to the same input as the video selection
6.3 Setting the Audio Output Gain
You can set the audio output gain using the + and – buttons
To set the audio output gain:
1. Ensure that the Audio button is lit and that the VIDEO button is not lit.
2. Press the input button of the input for which you want to set the audio gain.
The input button lights.
3. Press either the + (to increase) or – (to decrease) button to vary the gain.
6.4 Reading and Writing the EDID
The VP-31KSi is delivered with preprogrammed EDID data for each input (see
Section 6.4
). Using the Kramer EDID Designer software
7
Operating the VP-31KSi Remotely
you can read and write
EDID data to individual inputs.
You can operate the VP-31KSi remotely using the Kramer K-Single Control
Software on a PC. For full details, see the Kramer Control Software Online Guide.
The VP-31KSi can be operated remotely via any of the following methods:
•
The Kramer RC-IR3 Infra-Red Remote Control transmitter
•
Contact closure switches (for connecting, see
Section 5.2
•
SI-1VGA Remote Step-in Panel (for connecting, see
Section 5.3
•
RS-232 (for connecting, see
Section 5.4
•
RS-485 (for connecting, see
Section 5.6
•
Ethernet over a LAN using a Web browser (see
Section 8
1 You can set the audio input gain for each input individually using the IR remote control or Protocol 2000/3000 commands via
RS-232/Ethernet
2 The Kramer EDID Designer software can be downloaded fro