Kramer Electronics VP-31KSi - Manual (Page 15)

Connecting the VP-31KSi 3x1 UXGA/Audio STEP-IN Switcher
11
To connect remote input selection switches as the example illustrated in
Figure 6 :
1. Connect Switch A to pins 1 and G (ground) on the terminal block.
2. Connect Switch B to pins 2 and G on the terminal block.
3. Connect Switch C to pins 3 and G on the terminal block.
5.3 Connecting the SI-1VGA Remote Step-in Module
For detailed instructions refer to the SI-1VGA Step-in Module Installation
Instructions 1
To connect an SI-1VGA remote step-in module to the VP-31KSi as illustrated
in the example in
.
Figure 7 :
1. Mount the SI-1VGA in either the TBUS-10 or the K-POD301.
2. Using a 15-pin HD (male to male) cable 2
3. Using an audio cable with 3.5mm mini jacks at both ends
, connect the 15-pin HD connector
on the rear of the SI-1VGA to the corresponding input on the rear of the
VP-31KSi.
3
4. Repeat steps 2 and 3 for each SI-1VGA remote step-in module.
, connect the
3.5mm mini connector on the rear of the SI-1VGA to the corresponding audio
input on the rear of the VP-31KSi.
Figure 7: Connecting the SI-1VGA
1 Available for download from http://www.kramerelectronics.com
2 For example, Kramer C-GM/GM
3 For example, Kramer C-A35M/A35M