Kramer Electronics VP-28 User Manual
Page 40
36
VP-28 - Kramer Protocol
Identification commands
Command
Syntax
Response
Ethernet Commands
Set IP address
NET-IP IP_ADDRESS
Short form:
NTIP
NET-IP IP_ADDRESS RESULT
Read IP address
NET-IP?
Short form:
NTIP?
NET-IP IP_ADDRESS
Read MAC address
NET-MAC?
Short form:
NTMC
NET-MAC MAC_ADDRESS
Set subnet mask
NET-MASK SUBNET_MASK
Short form:
NTMSK
NET-MASK SUBNET_MASK RESULT
Read subnet mask
NET-MASK?
Short form:
NTMSK?
NET-MASK SUBNET_MASK
Set gateway address NET-GATE GATEWAY_ADDRESS
Short form:
NTGT
NET-GATE GATEWAY_ADDRESS
RESULT
Read subnet mask
NET-GATE?
Short form:
NTGT?
NET-GATE GATEWAY_ADDRESS
Set DHCP mode
NET-DHCP DHCP_MODE
Short form:
NTDH
NET-DHCP DHCP_MODE RESULT
Read subnet mask
NET-DHCP?
Short form:
NTDH?
NET-DHCP DHCP_MODE
DHCP_MODE =
‘0’ – Don't use DHCP (Use IP set by factory or IP set command).
‘1’ – Try to use DHCP, if unavailable use IP as above.
Change protocol
Ethernet port
ETH-PORT PROTOCOL , PORT
Short form
: ETHP
ETH-PORT PROTOCOL ,PORT
RESULT
Read protocol
Ethernet port
ETH-PORT? PROTOCOL
Short form:
ETHP?
ETH-PORT PROTOCOL , PORT
PROTOCOL = TCP/UDP (transport layer protocol)
PORT = Ethernet port that accepts Protocol 3000 commands
1-65535 = User defined port
0 - Reset port to factory default (50000 for UDP, 5000 for TCP)
Factory Commands
Reset to factory
default configuration
FACTORY
FACTORY RESULT