Kramer Electronics VP-28 - Manual (Page 14)

10 VP-28 - Connecting the VP-28
3. Connect the composite VIDEO OUT RCA connector to a composite video
acceptor (for example, a projector).
4. Connect an HDMI source (for example, a DVD player) to the HDMI IN 1
HDMI connector.
5. Connect the HDMI OUT connector to an HDMI acceptor (for example, an
LCD TV).
6. Connect a DisplayPort video source (for example, a laptop) to the DP IN 1
DP connector.
7. Connect the DP OUT connector to a DisplayPort video acceptor (for
example, a projector).
8. Connect the DVI AUDIO OUT 3.5mm mini jack connector to an unbalanced,
stereo audio acceptor (for example, a power amplifier).
9. Connect a DVI source (for example, a computer) to the DVI IN 1 connector.
Note: Using the Kramer ADC-DM/DF+GF combined cable increases the
input options available to you.
10. Optional—Connect a PC via Ethernet over a LAN to the Ethernet RJ-45
connector to control the VP-28.
5.1 Connecting a Serial Controller to the VP-28
You can connect to the VP-28 via an RS-232 connection using, for example, a
PC.
To connect to the VP-28 via RS-232:
• Connect the 3-pin terminal block on the rear panel port of the VP-28 (pin G
to pin 5, pin Rx to pin 3, pin Tx to pin 2) to the RS 232 9-pin D-sub port on
your PC