Kramer Electronics VP-28 - Manual (Page 24)

20 VP-28 - Operating the VP-28 Remotely
3. For Ethernet, enter the IP address and Port number of the device and click
Connect.
To set the default IP address and Port number, press the
Default button.
4. For a serial connection, select the required Com port from the drop-down
list.
5. Click Connect.
If the connection is successful, the window shown in Figure 8 appears. If the
connection is not successful, a Timeout error message appears.
7.3 Switching an Input to the Output of the Group
To switch an input to the output of the group:
• Click on the required input button to activate it.
The input is selected and the button changes to solid purple as shown in
Figure 11 .
Figure 11: Input Selection
7.4 Selecting a Master Audio Input
To select a master audio input:
1. Click on the Master Audio drop-down list as shown in Figure 12 .
Figure 12: Master Audio Input Selection
2. Select the required audio input from the drop-down list.
The audio input is selected to switch to the master audio output.