beautypg.com

Kramer Electronics TP-410 User Manual

Page 9

background image

T

P

-4

10

O

ver

vi

e

w

6

Figure 2: TP-410 UXGA-Audio-RS-232 Line Transmitter / DA Rear Panel

#

Feature

Function

8

EDID

STATUS LED

Lights during normal operation; blinks when acquiring the EDID

9

CAPTURE Button

Press to acquire the EDID information from the display (see

Section 9

10

)

AUDIO
OUT

ANALOG 3.5mm Mini
Connector

Connect to an unbalanced stereo audio local acceptor to monitor any audio source

11

S/PDIF LOOP RCA Connector

Connect to a digital audio local acceptor to monitor any audio source

12

AUDIO
INPUTS

S/PDIF AUDIO RCA Connector

Connect to the selectable digital audio source

13

ANALOG AUDIO 3.5mm Mini
Connector

Connect to the selectable unbalanced stereo audio source

14

TP IN

EQ. Trimmer

Adjusts the cable compensation (equalization) level for the UXGA (RJ-45 TP input)

Degradation and VGA/XGA signal loss can result from using long cables (due to the effects of
stray capacitance, for example), sometimes leading to a loss of sharpness in high-resolution
signals

Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level

15

LEVEL Trimmer

Adjusts the output signal level for the UXGA (RJ-45 TP input)

Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level

16

RJ-45 Connector

Connect to the LINE OUT connector of a transmitter (the PINOUT is defined in

Section 8

17

),

for example, the TP-125EDID

OUT 15-pin HD Connector

Connect to a local display to monitor any computer graphics source

18

UXGA IN 15-pin HD Connector

Connect to a computer graphics source

19

TP OUTPUTS RJ-45 Connectors

Connect to the LINE IN RJ-45 connector on a receiver, for example, the TP-126 (from 1
to 10)

Using a UTP CAT 5 cable with RJ-45 connectors at both ends (the PINOUT is defined in

Section 8

20

)

RS-232 (Tx, Rx, G)

Connect to the RS-232 controller (PINs 2, 3 and 5 of a standard 9-pin D-sub connector –
see

Section 5.2

)