7 the setup dip-switches, 1 setting the machine number, The setup dip-switches – Kramer Electronics TP-410 User Manual
Page 22: Setting the machine number, Figure 12: the address # dip-switches, 7the setup dip-switches
TP-410 - The SETUP DIP-switches
19
19
7
The SETUP DIP-switches
The DIP-switches on the TP-410 set the machine number of the unit.
Moving a DIP-switch down turns the switch on, moving it up turns the
switch off. Changing any DIP-switch requires that you turn the TP-410
power off and then on again.
7.1
Setting the Machine Number
To control a unit remotely via RS-232, RS-485 or the Ethernet, each unit has to be
identified via its unique machine #. DIP-switches 1, 2, 3 and 4 set the machine
number (according to the table below).
Figure 12: The Address # DIP-switches
Add. #
DIP 1
DIP 2
DIP 3
DIP 4
Add. #
DIP 1
DIP 2
DIP 3
DIP 4
1
OFF
OFF
OFF
OFF
9
OFF
OFF
OFF
ON
2
ON
OFF
OFF
OFF
10
ON
OFF
OFF
ON
3
OFF
ON
OFF
OFF
11
OFF
ON
OFF
ON
4
ON
ON
OFF
OFF
12
ON
ON
OFF
ON
5
OFF
OFF
ON
OFF
13
OFF
OFF
ON
ON
6
ON
OFF
ON
OFF
14
ON
OFF
ON
ON
7
OFF
ON
ON
OFF
15
OFF
ON
ON
ON
8
ON
ON
ON
OFF
When using a single unit, set the unit to Address # 1.
Do not use the 1111 DIP-switch combination for normal operation
(see
Section 10
After setting a new machine number, turn the power off and then on again.
i
i