Kramer Electronics TP-410 - Manual (Page 3)

TP-410 – Contents i
Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
3 Overview 3
3.1 Shielded Twisted Pair (STP) / Unshielded Twisted Pair (UTP) 4
3.2 Defining EDID 4
3.3 Defining the TP-410 UXGA-Audio-RS-232 Line Transmitter / DA 4
4 Installing in a Rack 8
5 Connecting the TP-410 9
5.1 Connecting the TP-410 9
5.2 Connecting to the TP-410 via an RS-232 Connection 11
5.3 Connecting to the TP-410 via an RS-485 Connection 11
5.4 Connecting to the TP-410 via the ETHERNET 12
5.5 Connecting Several TP-410 Units 14
6 Configuration and Distribution of Control Data 15
6.1 The Local Mode 15
7 The SETUP DIP-switches 19
7.1 Setting the Machine Number 19
7.2 Setting the RS-232/RS-485 Baud Rate DIP-switches 20
7.3 Setting the RS-485 Bus Termination 21
8 Wiring the CAT 5 LINE IN / LINE OUT RJ-45 Connectors 22
9 Acquiring the EDID 23
10 Flash Memory Upgrade 24
11 Technical Specifications 25
11.1 Communication Parameters 26
12 Default EDID 27
13 Kramer Communication Protocol 2000 28
Figures
U
Figure 1: TP-410 UXGA-Audio-RS-232 Line Transmitter / DA Front Panel
U
5
U
Figure 2: TP-410 UXGA-Audio-RS-232 Line Transmitter / DA Rear Panel
U
6
U
Figure 3: Connecting the TP-410, UXGA-Audio-RS-232 Line Transmitter / DA
U
10
U
Figure 4: RS-232 Pinout
U
11
U
Figure 5: Local Area Connection Properties Window
U
13
U
Figure 6: Internet Protocol (TCP/IP) Properties Window
U
13
U
Figure 7: Connecting Multiple TP-410 Units
U
14
U
Figure 8: Local Control via RS-232
U
16
U
Figure 9: Control via the Ethernet
U
16
U
Figure 10: RS-232 Remote Control
U
17
U
Figure 11: Connecting Multiple TP-410 Units via RS-485
U
18
U
Figure 12: The Address # DIP-switches
U
19
U
Figure 13: TP-410 Baud Rate DIP-switches
U
20
U
Figure 14: TP-410 DIP-switch RS-485 Termination
U
21
U
Figure 15: CAT 5 PINOUT
U
22