1 eth configuration, 2 setting the rs-232/rs-485 baud rate dip-switches, Setting the rs-232/rs-485 baud rate dip-switches – Kramer Electronics TP-410 User Manual
Page 23: Figure 13: tp-410 baud rate dip-switches
20
TP-410 - The SETUP DIP-switches
7.1.1
ETH Configuration
To configure the Ethernet parameters, set DIP-switches 1 to 4 to ON (ON-ON-ON-
ON), turn the power off and then turn the power on again.
Use the Kramer K-UPLOAD software to configure the Ethernet.
The latest version of K-UPLOAD and installation instructions can be
downloaded from the Kramer Web site a
7.2
Setting the RS-232/RS-485 Baud Rate DIP-switches
DIP-switches 5, 6 and 7 set the serial port baud rate.
In a multiple device configuration, all devices must be set to the same
baud rate.
Figure 13: TP-410 Baud Rate DIP-switches
Baud Rate
DIP-switch
5
6
7
1200
OFF
OFF
OFF
2400
ON
OFF
OFF
4800
OFF
ON
OFF
9600 (default)
ON
ON
OFF
19200
OFF
OFF
ON
i
i
See also other documents in the category Kramer Electronics Accessories for electrical:
- VM-114H (22 pages)
- VM-114H2C (25 pages)
- VM-114H4C (23 pages)
- VS-81ETH (41 pages)
- VS-81ETH (27 pages)
- VM-9T (13 pages)
- VP-12NHD (15 pages)
- VP-5R (20 pages)
- VP-6A (15 pages)
- PT-5R/T (13 pages)
- TP-102HD (13 pages)
- TP-104HD (33 pages)
- TP-112HD (13 pages)
- TP-114 (13 pages)
- TP-202 (15 pages)
- TP-205A (15 pages)
- TP-210 (14 pages)
- TP-210A (15 pages)
- tp-219hd (16 pages)
- TP-305A (15 pages)
- TP-310A (18 pages)
- VM-1H4C (17 pages)
- VP-200xlT (31 pages)
- VP-300THD (12 pages)
- VPM-2 (42 pages)
- SI-1VGA (2 pages)
- SID-DP (2 pages)
- SID-DVI (2 pages)
- SID-H (2 pages)
- SID-VGA (2 pages)
- SID-X1 (23 pages)
- SID-X1 (2 pages)
- SID-X1N (23 pages)
- SID-X2N (31 pages)
- SID-X3N (22 pages)
- 622R (17 pages)
- VS-169TP (7 pages)
- VS-169TP (45 pages)
- WSI-1VGA (2 pages)
- TP-107AV (32 pages)
- WP-500 (2 pages)
- SV-552 (22 pages)
- WP-501 (16 pages)
- RC-62 (94 pages)