Kramer Electronics TP-410 - Manual (Page 10)

# Feature Function
21 RS-485 (G,B,A) Connect to the RS-485 controller.
Pins B (-) and A (+) are for RS-485; connect pin G to the cable shield (if required)
22 ETHERNET Connector Connects to the PC or other Serial Controller through computer networking
23 FLASH N/A (for factory use only)
24 FACTORY RESET
Turn the machine OFF using the power switch and then turn it ON while pressing the
FACTORY RESET button. The unit will power up and load its memory with the following
factory default definitions: default Ethernet settings (IP address: 192.168.1.39; TCP port
#: 5000 and UDP port #: 50000); RS-232 data is distributed to all 10 outputs and is
received by output 1 and the default EDID is acquired
25 SETUP DIP-switches For setup of the unit (see Section 7
26
)
Power Connector with Fuse AC connector enabling power supply to the unit
27 Power Switch Switch for turning the unit ON or OFF
7
T
P
-4
10
–
O
ver
vi
e
w