4 connecting the sec-st to the power supply, 5 connecting the sec-st to the controller (spc200), Connecting the sec−st to the power supply – Festo Контроллер двигателя SEC-ST User Manual

Page 52: Connecting the sec−st to the controller (spc200)

3. Installation

3−10

Festo SEC−ST−48−6−P01−EN en 0606c

3.3.4

Connecting the SEC−ST to the power supply

1. Make sure that the power supply is switched off.

2. Insert the plug into socket X3 of the SEC−ST.

3. Connect the PE cable of the mains supply to the earth

terminal PE.

3.3.5

Connecting the SEC−ST to the controller (SPC200)

1. Make sure that the power supply is switched off.

2. Insert plug X1 into the socket on the SEC−ST.

3. Connect the earthing strap of the cable to the earth

terminal PE.

4. Insert the 15−pin sub−D plug connector into the stepper

motor control card socket.