Festo Контроллер двигателя SEC-ST - Manual (Page 51)

3. Installation
3−9
Festo SEC−ST−48−6−P01−EN en 0606c
3.3.2 SEC−ST complete system
A complete SEC−ST system is shown in Fig. 3/6 on the previĆ
ous page. The following components are required for operatĆ
ing the SEC−ST:
ć Power unit 24...48 V DC / PELV voltage source
ć SEC−ST−48−6−P01
ć Motor (MTR−ST−...)
ć Cable for controller (KSPC−SECST−1.5)
ć Motor cable (KMTR−ST−5, 10 or x)
ć Controller (PLC e.g. SPC200 with stepper motor card
SPC200−SMX−1)
3.3.3 Connecting the motor to the SEC−ST
1. Insert the 9−pin sub−D plug for the power cable into the
appropriate socket on the motor.
2. Connect the motor cables to the screw terminal of the
plug.
3. Connect the PE cable of the motor to the earth terminal PE.
4. If applicable, connect the brake cables to the controller.
5. Check all plug connectors once again.