Festo Контроллер крайних положений SPC11 - Manual (Page 24)

1. Summary of components
1−12
Festo P.BE−SPC11−DSMI−EN en 0910b
Fixed stops ( 7 )
If the DSMI−... is operated in conjunction with the SPC11,
fixed stops will be required. By means of the fixed stops, the
end positions can be set as desired. Notes on setting the
fixed stops can be found in the operating instructions for the
DSMI−... .
Please note
During the teach procedure, a work load is pressed against
the fixed stops at a pressure up to the level of the operatĆ
ing pressure. Make sure that the fixed stops can withstand
this pressure, in order that the SPC11 can ascertain exactly
the end positions during the teach procedure.
Please note
In order to avoid damage caused by uncushioned moveĆ
ment into the end positions, the teach procedure must be
carried out again after the fixed stops have been adjusted
and components and tubing have been replaced.